Updated gartenhaus light

poolcoversensor.yaml

@@ -0,0 +1,95 @@
+esphome:
+  name: poolcoversensor
+
+esp32:
+  board: esp32-poe
+  framework:
+    type: arduino
+
+# Enable logging
+logger:
+
+# Enable Home Assistant API
+api:
+  password: !secret ota_password
+
+ota:
+  password: !secret ota_password
+
+#wifi:
+#  ssid: "WLAN"
+#  password: !secret wifi_password
+#
+#  # Enable fallback hotspot (captive portal) in case wifi connection fails
+#  ap:
+#    ssid: "Poolcoversensor Fallback Hotspot"
+#    password: !secret ota_password
+#captive_portal:
+
+ethernet:
+  type: LAN8720
+  mdc_pin: GPIO23
+  mdio_pin: GPIO18
+  clk_mode: GPIO17_OUT
+  phy_addr: 0
+  power_pin: GPIO12
+
+
+sensor:
+  - platform: ultrasonic
+    trigger_pin: 4
+    echo_pin: 36
+    name: "Poolcover Einstieg Abstand"    
+    icon: "mdi:door-sliding-open"
+    update_interval: 1s
+    timeout: 3m
+
+binary_sensor:
+  - platform: gpio
+    device_class: opening
+    name: "Poolcover Vorne Einstieg"
+    icon: "mdi:waves-arrow-right"
+    filters:
+      - delayed_on: 100ms
+    pin: 
+      number: 16
+      mode:
+        input: true
+        pullup: true
+  - platform: gpio
+    device_class: opening
+    name: "Poolcover Mitte"
+    icon: "mdi:waves-arrow-up"
+    filters:
+      - delayed_on: 100ms
+    pin: 
+      number: 15
+      mode:
+        input: true
+        pullup: true
+  - platform: gpio
+    device_class: opening
+    name: "Poolcover Ende"
+    icon: "mdi:waves-arrow-left"
+    filters:
+      - delayed_on: 100ms
+    pin: 
+      number: 14
+      mode:
+        input: true
+        pullup: true
+
+# Those pins act as GND to be connected with the binary inputs
+switch:
+  - platform: gpio
+    id: gndpin1
+    pin: 13
+    internal: true
+  - platform: gpio
+    id: gndpin2
+    pin: 2
+    internal: true
+  - platform: gpio
+    id: gndpin3
+    pin: 5
+    internal: true