esphome:
  name: modbustester 

esp32:
  board: esp32-poe
  framework:
    type: arduino

# Enable logging
logger:

# Enable Home Assistant API
api:
  #password: !secret ota_password
  encryption:
    key: !secret api_encryption_key

ota:
  password: !secret ota_password


ethernet:
  type: LAN8720
  mdc_pin: GPIO23
  mdio_pin: GPIO18
  clk_mode: GPIO17_OUT
  phy_addr: 0
  power_pin: GPIO12


uart:
  - id: uart_for_modbus
    rx_pin: 1
    tx_pin: 0
    baud_rate: 19200
    stop_bits: 1
    parity: NONE

modbus:
  uart_id: "uart_for_modbus"
  id: modbus_comp

modbus_controller:
  - modbus_id: "modbus_comp"
    id: oxilife
    address: 0x1
    update_interval: "1s"

sensor:
  #- platform: modbus_controller
  #  modbus_controller_id: oxilife
  #  id: oxilife_ionization_current 
  #  name: Ionization Strom
  #  address: 0x0100
  #  value_type: U_WORD
  - platform: modbus_controller
    modbus_controller_id: oxilife
    id: tester_oxilife_hidro_current 
    name: Test Oxilife Hydro Strom
    address: 0x0101
    register_type: read
    value_type: U_WORD
  - platform: modbus_controller
    modbus_controller_id: oxilife
    id: tester_oxilife_ph
    name: Test Oxilife pH
    address: 0x0102
    register_type: read
    value_type: U_WORD
    accuracy_decimals: 2
    filters:
      - multiply: 0.01
  - platform: modbus_controller
    modbus_controller_id: oxilife
    id: tester_oxilife_redox_level 
    name: Test Oxilife Redox Level
    address: 0x0103
    register_type: read
    value_type: U_WORD
    unit_of_measurement: "mV"